Echelon i.LON 600 LonWorks/IP Server - Manual (Page 23)

Section 1: Setting Up and Using the i.LON 600 Internet Server
i.LON 600 LED Displays and Buttons
Once you have applied power to your i.LON 600, LEDs will provide you with
information on the status of your i.LON 600.
Table 5 describes each LED and its
meaning.
Table 5. LED Status Information
LED Description
Power This LED is on when the i.LON 600 unit has power. When i.LON 600 applications
are not running, this light blinks rapidly.
Service This LED is normally off. Blinking indicates the router is not configured. This LED
is solid ON when the i.LON 600 is in Security Access Mode (see Setting the i.LON
600 Security
in Chapter 4).
LAN Link Lights when an Ethernet connection has been established.
LAN ACT Lights when there is activity on the Ethernet connection.
LAN 100 Lights when the Ethernet connection is at 100 Mbps.
LON Connect This light is OFF if the i.LON 600 has not been configured in a L ON W ORKS /IP
channel by the Configuration Server. If the i.LON 600 has been configured in a
L
ON W ORKS /IP channel, but needs updating, the light will blink. The light stays
solid ON when the i.LON 600 has a current configuration for a L ON W ORKS /IP
channel.
LON RX Lights when a packet is received on the FT-10/TP-1250 port.
LON TX Lights when a packet is transmitted on the FT-10/TP-1250 port.
The i.LON 600 has two buttons: the service pin and the reset switch. The service pin is a
recessed pushbutton that sends L
ON W ORKS service pin messages on the L ON W ORKS
channels. You can use this button to commission an i.LON 600 with LonMaker or
perform a security access reset (described later in this document).
The reset switch is a concealed pushbutton used to reset the i.LON 600 server and is
located to the left of the LAN 100 LED. You can use a straightened paper clip to access
the reset switch. See
Figure 8 .
Reset Switch Service Pin and LED
Figure 8. i.LON 600 Service Pin and Reset Switch
i.LON 600 User’s Guide 15