Echelon i.LON 600 LonWorks/IP Server - Manual (Page 37)

Section 1: Setting Up and Using the i.LON 600 Internet Server
Setting Your PC’s IP Configuration
This may not work if your PC uses DHCP to obtain an IP address. You may need to set
your PC to a static IP address.
The i.LON 600’s IP address change may place the i.LON 600 on a subnet that your
computer cannot communicate with. For example: in order to communicate with the
i.LON 600 after a Security Access Reset, you can either modify your computer’s IP
configuration to place it on the 192.168.1.* subnet or enter the following command in the
Windows Command Prompt:
route add 192.168.1.0 mask 255.255.255.0 %COMPUTERNAME%
This command allows your computer to communicate with the i.LON 600 even when
they are not on the same subnet. This command does not persist through computer
reboots, but you can include the “–p” switch to make it persistent.
i.LON 600 Security Web Page
To access the Security Web page, perform a security access reset as described above,
point your browser to 192.168.1.222, and click Security. The following Web page
opens:
Figure 17. Security Web Page
This Web page allows you to enter the following options (you must click the Submit
button after changing any options):
FTP User name The FTP user name for the i.LON 600. The default user name is
ilon
. The
user name can be up to 20 characters long and may contain letters, numbers,
and the underscore character.
FTP Password The FTP password for the i.LON 600. The default password is
ilon
. The
password will appear as asterisks. The password can be up to 20 characters
long and may contain letters, numbers, and the underscore character.
Re-enter Password Reenter the FTP Password.
Enable FTP This option allows FTP access to the i.LON 600. This option is enabled by
default, but in most cases should be disabled once the system is installed.
i.LON 600 User’s Guide 29