Labconco Purifie Horizontal Clean Benches 38185 Series, 8' - Manual (Page 14)

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
Original Instructions
Plus the Following:
Part # Component Description
3876800 User’s Manual
1337100 Power Cord, 115V
Or (one of the following)
1338000 Power Cord, 230V United States
1332600 Power Cord, 230V United Kingdom
1336100 Power Cord, 230V Schuko
1332700 Power Cord, 230V China/Australia
If you did not receive one or more of the components listed for your clean bench,
or if any of the components are damaged, contact the Labconco Product Service
Department immediately for further instructions @ 1-800-821-5525.
Removing the Shipping Skid
LEAVE THE CLEAN BENCH ATTACHED TO ITS SHIPPING
SKID UNTIL IT IS AS CLOSE TO ITS FINAL LOCATION AS
POSSIBLE. MOVE THE UNIT BY USING A SUITABLE
FLOOR JACK, OR BY PLACING A FURNITURE DOLLY
UNDERNEATH THE SKID. DO NOT MOVE THE BENCH BY
TILTING IT ONTO A HAND TRUCK.
After you verify the clean bench components, move your clean bench to the
location where you want to install it. Then, follow the steps listed below to
remove the shipping skid from your unit.
To remove the shipping skid:
1. Remove the plastic wrapping and corner posts. Remove the packaging
material from the top of the bench.
2. Remove and discard the four bolts that secure the unit to the skid, as shown in
Figure 3-1.
)