Labconco Purifie Horizontal Clean Benches 38185 Series, 8' - Manual (Page 27)

Chapter 5: Using Your Clean Bench
Product Service 1-800-522-7658 23
Original Instructions
• Avoid the use of an open flame.
• Use proper aseptic technique. – “Sterile Air First”
• Avoid using techniques or procedures that disrupt the airflow patterns of
the clean bench.
Final Purging
• Upon completion of work, the clean bench should be allowed to operate
for 2 to 3 minutes undisturbed, to purge airborne contaminants from the
work area.
Wipe-Down
• Wipe down the interior surfaces of the clean bench with stainless steel
cleaner or 70% ethanol and allow to dry.
Shutdown
• Turn off the fluorescent light and clean bench blower.
Operating the UV Light
To activate the ultraviolet light, the following steps must be taken:
1. Turn the blower switch to the “Off” position, as shown in Figure 5-1.
2. Lower the UV Shade to the worksurface.
3. Select the desired length of time by pressing the Timer Button repeatedly
until the appropriate value is selected. Selecting the Infinity “∞” value
will activate the UV light until you manually deactivate it.
4. Set the Light Switch to the “UV” position, as shown in Figure 5-1.
U.V. Light is restricted by interlock. Blower Switch must be in
off position for U.V. Light operation. Avoid direct exposure of
eyes and skin to ultraviolet light.
La lumière ultrviolette est interdit par verrouillage.
L’interrupteur du ventilateur doit être dans la position d’arrête
pour le fonctionnement de la lampe. Evitez toute exposition
directe aux yeux et à la peau de la lumière ultraviolette.
!
!