Labconco Purifie Horizontal Clean Benches 38185 Series, 8' - Manual (Page 37)

Chapter 6: Maintaining Your Clean Bench
Product Service 1-800-522-7658 33
Original Instructions
2. Look to see how far away from the UV Lockout Sensor the Sensor Bracket is,
it should be approximately ¼” (6 mm) or closer to the white, round, Lockout
Sensor in the Stainless Steel Worksurface.
3. Turn on the UV Light as described in Chapter 5, Section Operating the UV
Light. If the UV Light does not come on, or is on intermittently, slide the
Sensor Bracket towards the Lockout Sensor by loosening the two screws
(shown below in Figure 6-7), moving the Bracket, and then retightening the
two screws when the Bracket is in a position that allows the UV Light to
remain on constantly with the UV Shade sitting in a normally closed position.
Note - Do NOT over tighten the two screws holding the Sensor Bracket onto
the UV Shade Handle.
Storage
IF THE CLEAN BENCH IS TO BE LEFT UNUSED FOR MORE
THAN ONE MONTH THE UNIT SHOULD BE PREPARED
FOR STORAGE.
1. Unplug the clean bench.
2. Cover and seal the prefilter and the work area opening with plastic sheeting.
The clean bench should not be stored in areas of excess
humidity or temperature extremes. If the clean bench is
moved during storage, it should be recertified before use.
L’hotte ne doit pas être entreposés dans des zones de l’excès
d’humidité ou de températures extrêmes. Si l’hotte est déplacée
pendant le stockage, il doit être certifié de nouveu avant
l’utilisation.
)
!
!
Figure 6-7
Sensor
Bracket
(2) Sensor
Bracket
Screws
UV Shade
Handle