Laerdal VitalsBridge - Manual (Page 36)

VitalsBridge Directions for Use
35
rev. B.7 PN 10229
12. Input the SSID (i.e., the name of the network) and password that is set for you SimMan 3G’s
internal router. Click the “Submit” button.
13. The Network Configuration Tool will configure the VitalsBridge to connect to the SimMan3G
wirelessly. Configuration takes approximately 1 minute. Do not power off the VitalsBridge
during this process.
14. The process is complete when the Network Configuration Tool dialog box reads “Power Cycle
VitalsBridge before attempting to connect via Wi-Fi”.
15. Turn off VitalsBridge.
16. Close Network Configuration Tool.
Your VitalsBridge is now set up to connect wirelessly.
VitalsBridge Network Configuration Using an External LAN
Consult your network administrator for assistance configuring the VitalsBridge on an external LAN.
Using an Ethernet cable, connect the VitalsBridge to a LAN where the PC is located. Note: the local area
network must have UDP multicasting installed.
LAN Manual Connection
For a manual LAN, uncheck the “Use DHCP” box in the Network Configuration Tool window, and check
the “Assign Manually” box. You may then input the IP, Gateway, and Subnet manually. Note: a
manually assigned LAN ip address is not recommended.