Laerdal VitalsBridge - Manual (Page 5)

VitalsBridge Directions for Use
4
rev. B.7 PN 10229
Warnings and Caution
Follow all cautions and warnings outlined in the SimMan3G Directions for Use.
The VitalsBridge is intended solely for use during patient simulation. It is not a medical device.
Warning: Never connect the VitalsBridge to a patient.
Warning: Never connect the VitalsBridge to a Vital Signs monitor that is connected to a patient.
Warning: The VitalsBridge is not waterproof. Protect the VitalsBridge in damp conditions and
keep away from liquids.
Warning: The VitalsBridge contains a lithium ion battery, which if damaged, could cause risk of
fire or explosion.
Compressed Gases and Regulators
Use only sources of compressed CO
2
with the VitalsBridge. Adequate training and expertise is required
to work with compressed gases.
The VitalsBridge is supplied with a portable CO
2
regulator that uses cartridges of highly pressurized CO
2
gas. Take care when handling these cartridges as they pose a potential risk of injury if used improperly.
Cartridges should be stored and operated at temperatures below 120
o F (49 o C) and punctures should be
prevented. They should not be heated. They should not be used or stored ate temperatures above 120 o
F or 49 o C. Do not inhale the CO
2
gas.
Warning: Do not use compressed oxygen (fire hazard) or any other flammable substance with or
near the VitalsBridge.
Warning: CO
2
cartridges may become extremely cold when discharging. Protect eyes and hands
when installing and handling CO
2
handling CO
2
cartridges.
Warning: Mishandled CO
2
cartridges may become a projectile.
Caution: CO
2
cartridges may not be transported by air.