Pitney Bowes DM1100 - Manual (Page 159)

DM1100™ Digital Mailing System Operating Guide
SV62146 Rev. D 9 - 5
Cleaning the
Moistener Brush 1. Move the tape lever to the
up position.
2. Move the brush lever to
the right to pull the brush
mechanism forward.
3. Lift the brush out by pull-
ing up on the bristles.
4. Rinse the brush under
cold water, separating the
bristles to remove excess
glue and deposits.
5. Place the brush in the
case, two or three teeth
away from the bottom.
The shorter bristles
should be against the
solid side of the holder.
6. Return the case to the
brush mechanism using
the lever.
7. Return lever to original
position.
8. Return tape lever to the
required position.
•
Wet Tape–Lever up
9. Dry Tape– Lever down
•
Replacing the
Moistener Brush Follow steps 1 through 7 of Cleaning the Moistener Brush, but DO NOT
perform step 4.
Printer
Maintenance
The printer components, consisting of the printer nozzle, ink cartridge and
printhead, require minimum maintenance to ensure clean, clear meter
imprints on your mail.
If the print quality deteriorates and you cannot improve it with the proce-
dures in this chapter, contact the Pitney Bowes Help Desk. Refer to the

Pitney Bowes Contact Information List at the front of this guide for the
phone number.
Brush Lever
Tape
Lever
Two to three teeth away from bottom
Short Bristles