Pitney Bowes DM1100 - Manual (Page 31)

DM1100™ Digital Mailing System Operating Guide
SV62146 Rev. D 3-3
• Place the envelopes with the flaps down and against the rear wall.
• Make sure the envelopes are pushed far enough so that they cover
the feed sensor on the rear wall.

5. Use the thickness adjustment
knob to adjust for envelope
thickness.
•
For thicker pieces of mail

(3/8” to 5/8”), or mail contain-
ing several inserts, use the
thick mail setting. For most
mail under 3/8", use the nor-
mal mail settings.
• For large stacks of thin mail,
such as single inserts or post
cards, the thin mail setting
may be needed for better
performance. Refer to the
figure on the right.
To pick a setting, turn the knob
to the arrow located on the feed
cover.
6. Make sure you have sufficient funds in your postage meter. If the mes-
sage “Low Funds” appears on the screen, make sure you can complete
the mail run with the funds you have. If you do not have enough funds,
see Chapter 6, Adding Postage in this guide.
Running the
Mail
1. Press the Mode key on the IntelliLink® Control Center.
2. Select Key In Postage.
3. Key in the correct postage value using the numeric keys on the control
center, then press the Enter key.
4. Place the piece of mail on the feed deck and press the Start key.
Normal Mail Setting
Thick Mail
Setting
Thin Mail
Setting