Rocktron Taboo Twin - Manual (Page 13)

10
6 T AP D ELAY jack
This ¼" mono jack allows for the connection of a momentary footswitch to control the
Tap Delay feature of the Taboo Twin. The Tap Delay function allows for the current
delay time to be set (or reset) by tapping the footswitch connected to the T
AP D ELAY
jack. The new delay time will be based on the length of time between two taps.
The Tap Delay function is discussed further in Chapter 7, Operating the Taboo Twin.
7 R EMOTE jack
This 7-pin DIN connector is provided for the connection of a Rocktron All Access ®
MIDI footswitch, which can be configured to act as a dedicated remote footswitch for
the Taboo Twin. This feature provides access to Taboo Twin functions and parameters
via the remote footswitch.
8 P HANTOM P OWER jack
This 2.5mm PIN jack provides the ability to power Rocktron MIDI foot controller from a
7-pin MIDI cable which connects from the MIDI Mate to the MIDI IN jack on the rear
panel of the Taboo Twin, thus eliminating the need to find an AC outlet near where the
footpedal would be placed during a performance—or the need to run an extension cord
out to the foot controller.
Instead of inserting the adaptor into the Rocktron foot controller's P OWER jack, plug it
into the P HANTOM P OWER jack on the Taboo Twin. This will power the foot controller
through pins 6 and 7 of the MIDI cable connecting the two units. A 7-pin MIDI cable
must be used for this feature and is available through your Rocktron dealer.
9 MIDI I N jack
This 7-pin DIN connector receives MIDI information from the device which is
transmitting the MIDI commands for the Taboo Twin to execute.