Rocktron Taboo Twin - Manual (Page 69)

66
Step 4 Press the S TORE button at this time to initiate the All Restore procedure and erase all current
Taboo Twin presets, replacing them with the original factory presets. The Taboo Twin will
display "INITIALIZING" as the Taboo Twin memory is restored.
INITIALIZING
After the All Restore process is completed, the display should read "ERRORS 0". This is the
number of bytes that the Taboo Twin found that did not initialize properly. Any number of
errors other than "0" means that the Taboo Twin may not have initialized properly and the
process should be repeated.
ERRORS 0
The Taboo Twin will remain in this condition until the M NEU button is turned to exit the Factory
Restore function. The preset currently recalled will be the preset most recently restored into the
current location.
The controller assignments for the Taboo Twin can also be reinitialized without affecting
presets and other stored information. Reinitialization of the controller assignments is necessary
when setting up the Taboo Twin to operate in remote mode with a Rocktron
All Access
footswitch.
To reinitialize only the controller assignments, enter a code number of "221" at Step 3 on
the opposite page.
Restoring the Taboo Twin controller assignments: