Taser X3 - Manual (Page 12)

12
4e Remove the protective label from the new EPM.
4f Install the new EPM. Ensure that the EPM is fully inserted into the X3 ECD. Apply sufficient
force to ensure the EPM is fully seated and the tabs on the sides of the EPM are properly engaged.
Optional Rechargeable TACOM Power Magazine (TPM)
The optional TPM is a rechargeable battery module with integrated TACOM wireless communication capability.
The TPM has enough power for approximately 100 discharges depending on temperature. The TPM will use
more energy in colder weather than warm weather. Battery life also will vary depending on the flashlight
usage.
Central Information Display (CID) Color Graphic User Interface
The display on the back of the X3 ECD provides information about the ECD. When the CAM-Lock safety is shifted
into the up (ARMED) position, the CID will display the cartridge bays, diagnostic status, and battery status.
Central Information Display (CID) Color Graphic User Interface
Cartridge Icons
Left to right: 35-, 25-, and 15-foot live cartridges. These cartridges have not been deployed.
Note that the cartridge icons are displayed in the same color as those of the blast door
colors for the corresponding ranges (orange for 35, green for 25, and yellow for 15).
10m 7m 4m
If your X3 ECD is set up for metric measurements, the same cartridges will be displayed
like this: 10, 7, and 4 meters in place of 35', 25', and 15', respectively. (Metric numbers are
rounded down on the CID.)
Training cartridges will display with a solid blue icon shown in English or metric depending
on the X3 ECD’s settings.
The currently selected cartridge will be surrounded by a green border. If you press the
trigger switch, this is the cartridge that will be deployed.
If you press the trigger switch, the cartridge energized icon will display while the NMI burst
is in progress.
After a cartridge has been expended, the cartridge deployed icon is displayed.
Chapter 3 Features & Operation