Taser X3 - Manual (Page 18)

18
Selected Cartridge
Training Mode
35-Foot Training Cartridge
Cartridge Locked
60% Remaining
Operating Mode (Manual)
The CID below shows an X3 ECD in the semi-automatic mode, with a battery 80 percent full. The first and
second cartridges should be ready for use; the first cartridge is selected. The third has a problem, and will not
deploy. See"Load the Smart Cartridges" section for instructions on how to unload an X3 ECD.
!
Selected Cartridge Cartridge Bay Error
Energy Cell Indicator;
80% Remaining
Operating Mode
(Semi-Automatic)
25-Foot Cartridges
The CID below shows an X3 ECD in the manual mode, with a battery 80 percent full. The ARC Switch is pressed
for a Warning Arc display or drive-stun, energizing all cartridge bays. The center cartridge is selected because
pressing the ARC switch, in either the manual or semi-automatic mode, advances the cartridge selection. The
third cartridge bay is empty.
2
Empty Cartridge Bay
Selected Cartridge
Energy Cell Indicator;
80% Remaining
Operating Mode (Manual)
All Cartridge Bays Energized
Seconds Elapsed in
Burst (2)
Top Laser
The laser installed in the X3 ECD is oriented to the approximate position of a top probe’s trajectory at 15 feet.
Range Adjusted Dual Laser Sight (RADLS)
This feature is designed to provide bottom dart alignment. The module has two lasers. One of the lasers is active
only when a standard-range Smart Cartridge is detected, and it is aligned with the approximate trajectory
of the bottom probe of a standard-range (15'/4 m or 25'/7 m) cartridge. The other laser is active only when
the long-range (35'/10 m) Smart Cartridge is detected, and is aligned with the approximate trajectory of the
bottom probe of a long-range cartridge.
Chapter 3 Features & Operation