Waldorf Blofeld Keyboard - Manual (Page 21)

Basic Operation
21 Blofeld User´s Manual
3. Use the left display parameter dial to edit the
Octave parameter of Oscillator 1.
Now you should be able to choose the 5 edit levels with
the navigation buttons
Oscillators, Filters, Modulation, Effects and
Arpeggiator
w
While editing display menu parameters, you can also
adjust panel parameters and vice versa.
w
All menu pages of the Blofeld are arranged one after
another in order of the signal flow. Use the
Selection dial
c to select these pages.
Viewing Parameter Values without Change
The Blofeld offers a special mode to check parameter
values without performing any changes.
☞
To check parameter values without changing them:
1. Press and hold the corresponding button in the
Parameter matrix. After a short while all four
parameter and the values are shown in the
display.
2. You can edit the parameters while holding the
buttons.
3. Release the button to end the parameter
viewing.
Comparing Edited Programs with Stored
Programs
The Compare function allows you to compare the
currently edited program to its original stored version in
the internal memory.
☞
To use the Compare function:
1. Press Shift + Utility.
2. Use the Selection dial c to locate the menu
page Compare Sound.
3. Press Shift + Utility to change between the
edited and the unedited version of your
program when you play the Blofeld. The letter
„c“ is displayed behind the corresponding
program number.
4. Press Shift + Utility again to go back to your
edited sound.