Waldorf Blofeld Keyboard - Manual (Page 84)

Global Parameter
Blofeld User´s Manual 84
• If Ctl is selected, only controller messages are sent.
Parameters without a dedicated controller are not
sent at all.
• If SysEx is selected, all Sound parameters are sent as
system exclusive messages. This has the advantage
that the parameter change is not channel based but
instrument based, which can avoid unwanted
parameter changes of layered sounds. The
disadvantage is a larger amount of data that is
transferred.
• If Ctl+SysEx is selected, all Sound parameters with a
dedicated controller assignment are sent as
controller messages. All other Sound parameters are
sent as system exclusive messages. This is the
recommended setting..
Ctrl Receive off / on
Determines if Real-Time Sound Parameter Changes are
received over MIDI by the Blofeld.
• If Off is selected, no Sound Parameter Changes are
received.
• If On is selected, all Sound Parameter Changes are
received, no matter if they were sent as controller or
system exclusive messages.
w
Set Ctrl Receive to On during normal operation.
You should only set it to Off for diagnostic purpose.
Control W...Z 0...120
These parameters are used to define arbitrary MIDI
Continuous Controllers as modulation sources for Sounds.
You can setup four Controls, W, X, Y and Z, for this
purpose. Each value represents a MIDI Continuous
Controller number that is used when you assign its
parameter as modulation source in the Modifiers or the
Modulation Matrix. The highest possible Controller
number is 120 because all higher numbers are reserved
for non-real-time purposes.