Waldorf Blofeld Keyboard - Manual (Page 87)

Global Parameter
87 Blofeld User´s Manual
☞
To activate the dump function in Play mode:
1. Use the Selection dial to select the desired
dump function:
• If Dump Sound is selected, the current
Sound program will be sent.
• If Dump Sound Bank is selected, the
current Sound Bank will be sent.
• If Dump All Sounds is selected, all Sound
programs of the Blofeld are sent.
• If Dump All all Sound programs and the
Global parameters are sent.
2. Press Shift + Utility to activate the dump.
☞
To activate the dump function in Multimode:
1. Use the Selection dial to select the desired
dump function:
• If Dump Multi is selected, the current
Multi program will be sent. All
corresponding sound programs will not
sended within this dump.
• If Dump Arrangement is selected, the
current Multi program including all
sound programs will be sent.
• If Dump All Multis is selected, all Multi
programs of the Blofeld are sent.
2. Press Shift + Utility to activate the dump
w
Depending on the selected type, the dump may take
some time. The Blofeld cannot be played during this
time.
Receiving System Exclusive Data
You are not required to activate a special receive mode of
the Blofeld in order to receive system exclusive data
through MIDI or USB. However, there are a few things
you should check before you transmit system exclusive
data to the Blofeld:
• Make sure none of the Blofeld’s programs is in Edit
mode. The edit buffers might be cleared or
overridden depending on the type of dump that is
sent to the Blofeld.
• Check out the parameter Device ID. Data
transmission will only be executed successfully if if
the sender and receiver settings match.