WaterFurnace Envision2 - Manual (Page 34)

34
ENVISION 2 COMPACT INSTALLATION MANUAL
Aurora UPC Features
• Rugged enclosure made of GE C2950 Cycoloy plastic
• Built-in surge transient protection circuitry
• Operating range of -20° to 140°F; 10 to 95% relative hu-
midity, non-condensing
• Onboard CR123A battery has a life of 10 years with 720
hours of cumulative power outage
• Multi-Protocol field selectable communication port
that supports:
• EIA-485 BACnet MS/TP @ 9600, 19.2k, 38.4k, 76.8k baud
• Metasys N2 Open
• LonWorks TP/FT-10 (Requires optional LON plug-in
communication card)
• Status of all unit operating conditions and fault lockouts
• Visual LED’s for status of power, network communication,
processor operation, and errors
• Provides gateway into Aurora heat pump controls for
unsurpassed control flexibility
• Network point for commanding unit into load shed
• Network point for commanding unit into
emergency shutdown
• Network points to assist in fan speed selection
• Network points for freeze protection settings
• Heating and cooling control from a remotely located
zone sensor
• Rnet communication port which allows for multiple Rnet
zone sensors (5) to be connected for space temperature
averaging if desired.
• Local laptop or BACview connection for field service
• FCC, UL and CE listed. BTL Certification is pending
N2
BACnet
LonWorks
BAS
Rnet
Modbus
Aurora UPC Optional Features
• BACview handheld display, needed for field configuration
of fan speeds, set points, etc.
• AID Tool for Aurora ABC configuration
and troubleshooting.
• Aurora Advanced Control adds the Aurora AXB
expansion board and provides added I/O and
standard features
• Optional Sensor Kits (requires Aurora Advanced
Control with AXB - Future Availability on Select
Models/Configurations)
• Refrigeration Monitoring – provides Suction and
discharge pressure, Suction, liquid line temps and
superheat and subcooling.
• Performance Monitoring – provides entering and
leaving loop water temperatures, loop flow rate as well
as heat of extraction or rejection rate into the loop.
• Energy Monitoring – provides real-time power
measurement (Watt) of compressor, fan, auxiliary heat
and zone pump.
• Graphics packages available in the future
Controls - UPC DDC Control (optional) cont.