Pilz PSS SB TESTER D - Manual (Page 16)

Operation
4-6 Operating Manual: PSS SB TESTER
Performing the tests
All the tests are described in detail in the chapter entitled “Tests/
Measurements”. This section is only intended to explain how to save,
upload and delete the test results.
Saving the test results
With the exception of the results for real-time mode, all the test results can
be saved.
The connection test, screening test, signal test and length measurement
each have a specific memory area available within the PSS SB TESTER.
This division within the memory enables tests to be performed at different
times; the respective results can be saved and then all the results can be
uploaded to the PC together. When you save the results of a test, the old
data in the test's memory area is overwritten.
Example: The user performs the connection test, saves the results and
switches off the tester. Two hours later the user then performs the signal
test, stores the results and again switches off the tester.
The current results from the connection test and signal test are saved
within the tester, along with the results from an earlier length
measurement.
• After carrying out a test, switch to the “Start” window and press F3.
• The “Memory” window opens. Use the arrow keys to move the cursor to
the symbol for “Save” and press VAL.
• The “Save” window opens. Press VAL.
The test results are saved. A message confirms that the results have been
saved. The “Start” window is then displayed again.
The test results are stored in a memory that is supplied by the battery. If
the battery is removed, the contents of the memory will be retained for 10
minutes. If it takes longer for the battery to be replaced, the contents of the
memory will be lost.