Factory default switch settings, Factory default switch settings –2, Factory – Altera DSP Development Kit, Stratix V Edition User Manual
Page 18
Advertising
4–2
Chapter 4: Development Board Setup
Factory Default Switch Settings
DSP Development Kit, Stratix V Edition
July 2013
Altera Corporation
User Guide
Factory Default Switch Settings
This section shows the factory switch settings for the Stratix V GS development board.
shows the switch locations and the default position of each switch on the
top side of the board.
Figure 4–1. Switch Locations and Default Settings on the Board Top
SW1
1
2
3
4
5
6
7
8
ON
ON = 0
OFF = 1
J8
2.5 V
1.8 V
1.5 V
Default: no jumper
installed for
2.5 V VCCIO
HSMB
VCCIO
User DIP
Switch
Advertising
This manual is related to the following products: