Altera Stratix IV GT 100G - Manual (Page 11)

October 2010 Altera Corporation Stratix IV GT 100G Development Kit User Guide
2. Getting Started
The remaining chapters in this user guide lead you through the following
Stratix IV GT 100G development board setup steps:
■ Inspecting the contents of the kit
■ Installing the design and kit software
■ Setting up, powering up, and verifying correct operation of the 100G development
board
■ Configuring the Stratix IV GT FPGA
■ Running the Board Test System designs
f
For complete information about the 100G development board, refer to the
Stratix IV GT 100G Development Board Reference Manual .
Before You Begin
Before using the kit or installing the software, check the kit contents and inspect the
board to verify that you received all of the items listed in
“Kit Features” on page 1–1 .
If any of the items are missing, contact Altera before you proceed.
Inspect the Board
To inspect board, perform the following steps:
1. Place the board on an anti-static surface and inspect it to ensure that it has not been
damaged during shipment.
c Without proper anti-static handling, you can damage the board.
2. Verify that all components are on the board and appear intact.
References
Use the following links to check the Altera website for other related information:
■ For the latest board design files and reference designs, refer to the
Stratix IV GT 100G Development Kit page.
■ For the Stratix IV GT device documentation, refer to the Literature: Stratix IV
Devices page.
■ To purchase devices from the eStore, refer to the Devices page.
■ For Stratix IV GT OrCAD symbols, refer to the Capture CIS Symbols page.
■ For Nios II 32-bit embedded processor solutions, refer to the Embedded
Processing page.