Altera Stratix IV GT 100G - Manual (Page 24)

6–2 Chapter 6: Board Test System
Stratix IV GT 100G Development Kit User Guide October 2010 Altera Corporation
A GUI runs on the PC which communicates over the JTAG bus to a test design
running in the Stratix IV GT device.
Figure 6–1 shows the initial GUI for a board that
is in the factory configuration.
Several designs are provided to test the major board features. Each design provides
data for one or more tabs in the application. The Configure menu identifies the
appropriate design to download to the FPGA for each tab.
After successful FPGA configuration, the appropriate tab appears and allows you to
exercise the related board features. Highlights appear in the board picture around the
corresponding components.
The Power Monitor button starts the Power Monitor application that measures and
reports current power information for the board. Because the application
communicates over the JTAG bus to the MAX II device, you can measure the power of
any design in the FPGA, including your own designs.
Figure 6–1. Board Test System Graphical User Interface