Altera Stratix IV GT 100G - Manual (Page 61)

Appendix A A–5
Restoring the MAX II CPLD to the Factory Settings
October 2010 Altera Corporation Stratix IV GT 100G Development Kit User Guide
13. The restore script cannot restore the board’s MAC address automatically. In the
Nios II command shell, type the following Nios II EDS command:
nios2-terminal
r
and follow the instructions in the terminal window to generate a unique MAC
address.
f
To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Stratix IV GT 100G Development Kit page of the Altera
website.
Restoring the MAX II CPLD to the Factory Settings
This section describes how to restore the original factory contents to the MAX II CPLD
on the 100G development board. Make sure you have the Nios II EDS installed, and
perform the following instructions:
1. Set the board switches to the factory default settings described in “Factory Default
Switch Settings” on page 4–2 .
1
The installed jumper for JTAG_EN (J41) includes the MAX II device in the
JTAG chain.
2. Launch the Quartus II Programmer.
3. Click Auto Detect.
4. Click Add File and select
<install dir>\kits\stratixIVGT_4sgt100g5_100g\factory_recovery\max2.pof.
5. Turn on the Program/Configure option for the added file.
6. Click Start to download the selected configuration file to the MAX II CPLD.
Configuration is complete when the progress bar reaches 100%.
f To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Stratix IV GT 100G Development Kit page of the Altera
website.