Altera Stratix IV GT 100G - Manual (Page 20)

4–4 Chapter 4: Development Board Setup
Factory Default Switch Settings
Stratix IV GT 100G Development Kit User Guide October 2010 Altera Corporation
3. Set the board jumpers to match Table 4–2 , as shown in Figure 4–1 .
f For more information about the FPGA board settings, refer to the Stratix IV GT 100G
Development Board Reference Manual .
Table 4–2. Jumper Settings
Board
Reference
Name
Default
Shunt Position
J40 USB DISABLE Not Installed
J41 JTAG_EN Installed
J42 VCCA_GXB DISABLE Not Installed
J55 FAN BYPASS ON Not Installed