Altera Stratix V Advanced Systems - Manual (Page 11)

Chapter 3: Software Installation 3–3
Installing the USB-Blaster II Driver
February 2013 Altera Corporation Stratix V Advanced Systems Development Kit
User Guide
The installation program creates the Stratix V Advanced Systems Development Kit
directory structure shown in
Figure 3–1 .
Table 3–1 lists the file directory names and a description of their contents.
Installing the USB-Blaster II Driver
The Stratix V GX advanced systems board includes integrated On-Board USB-Blaster
II circuitry for FPGA programming. However, for the host computer and board to
communicate, you must install the USB-Blaster II driver on the host computer.
f Installation instructions for the USB-Blaster II driver for your operating system are
available on the Altera website. On the
Altera Programming Cable Driver Information
page of the Altera website, locate the table entry for your configuration and click the
link to access the instructions.
Figure 3–1. Stratix V Advanced Systems Development Kit Installed Directory Structure (1)
Note to Figure 3–1 :
(1) Early-release versions might have slightly different directory names.
<install dir>
documents
board_design_files
The default Windows installation directory is C:\altera\ <version>\.
examples
factory_recovery
demos
kits
stratixVGX_5sgxea7nf45_as
Table 3–1. Installed Directory Contents
Directory Name Description of Contents
board_design_files
Contains schematic, layout, assembly, and bill of material board design files. Use these files as a
starting point for a new prototype board design.
demos Contains demonstration applications when available.
documents Contains the kit documentation.
examples Contains the sample design files for the Stratix V Advanced Systems Development Kit.
factory_recovery
Contains the original data programmed onto the board before shipment. Use this data to restore
the board with its original factory contents.