Factory default switch and jumper settings, Factory default switch and jumper settings –2 – Altera Stratix V Advanced Systems User Manual
Page 14
4–2
Chapter 4: Development Board Setup
Factory Default Switch and Jumper Settings
Stratix V Advanced Systems Development Kit
February 2013
Altera Corporation
User Guide
1
The kit includes a MAX V design which contains the MAX V PFL megafunction. The
design resides in the <install dir>\kits\stratixVGX_5sgxea7nf45_as\examples\max5
directory.
When configuration is complete, the Config Done LED (D13) illuminates, signaling
that the Stratix V GX devices configured successfully.
f
For more information about the PFL megafunction, refer to
Factory Default Switch and Jumper Settings
This section shows the factory switch and jumper settings for the Stratix V GX
advanced systems board.
shows the switch locations and the default position of each switch and
jumper on the top side of the board.
Figure 4–1. Default Settings
on the Board Top (Detail)
J3
VCCIO_FMC
1.8 V
1.5 V
1.2 V
Default:
no jumper installed
for 2.5 V
SW1
7
0
1
6543210
ON
J2
FA
N1
SW3
7
0
1
6543210
ON
J12
FAN2