BIXOLON SRP-500 - Manual (Page 13)

Rev. 1.08 - 13 -
SRP-500
2-2 Connecting the interface cable
Connect the printer to the host ECR (host computer) though an interface cable matching
the specification of the printer and the host ECR (host computer).
Be sure to use a drawer that matches the printer's specification.
Depending on the interface your system uses, either connect the serial, parallel or USB
communication cable to the appropriate connector on the back of the printer. Cables are
provided by your dealer or system installer.
Connect the interface cable according to the following procedure.
2-2-1 Turn off printer and the ECR (host computer) host.
2-2-2 Plug the interface cable into the interface connector on the printer then fasten the
screw on both sides of the connector.
2-2-3 Plug the drawer kick-out cable into the drawer kick-out connector on the printer.
(When removing the drawer kick-out cable, press on the connector's clip while pulling
out.)