BIXOLON SRP-500 - Manual (Page 14)

Rev. 1.08 - 14 -
SRP-500
3. Setting the Dip Switches
Although the factory settings are best for almost all users, if you have special requirements,
you can change the DIP switch. If you need to change settings, follow the steps below to
make your changes.
- Make sure the printer is turned off.
- Remove the screw from the DIP switch cover. Then take off the DIP switch cover,
which is shown in the illustration below.
- Set the switches using a pointed tool, such as tweezers or a small screwdriver.
- Replace the DIP switch cover. Then secure it with the screw.
- The new settings take effect when you turn on the printer.
※ NOTE
Turn off the printer before removing the DIP switch cover to prevent an electric short,
which can damage the printer.