BIXOLON SRP-500 - Manual (Page 16)

Rev. 1.08 - 16 -
SRP-500
3-2 Parallel / USB Interface (Parallel-IEEE1284)
Switch Function ON OFF Default
1-1
Emulation Selection Refer to the following table
OFF
1-2 OFF
1-3 Auto cutter Enable Disable ON
1-4 Cartridge one cartridge two cartridges OFF
1-5 Density
*1)
Bold Normal OFF
1-6 Special Function
*2)
Enable Disable OFF
1-7 Near end sensor Enable Disable ON
1-8 Undefined OFF
DIP switch Setting 1 Function
Emulation 1-1 1-2
BXL/POS OFF OFF
STAR OFF ON
BXL/POS-KP
*3)
ON ON
Emulation Selection
Switch Function ON OFF Default
2-1 Auto Line Feed Enable Disable OFF
2-2
Undefined
OFF
2-3 OFF
2-4 OFF
2-5 OFF
2-6 OFF
2-7 OFF
2-8 OFF
DIP switch Setting 2 Function
*1) : It may use in dark area. (like a restaurant). But printing speed to be slow down.
*2) : Enable = Automatically print NV bit image #1 after cutting.
*3) : Kitchen Printer mode : A alarm is generated by printer after auto-cutting and
in paper-end error. (It needs buzzer accessory)
※ NOTE
Changes in DIP switch settings are recognized only when the printer power is turned on or
when the printer is reset by using the interface. If the DIP switch setting is changed after
the printer power is turned on, the change does not take effect until the printer is turned on
again or is reset.