Junger Audio D*AP LM2 / D*AP LM4 - Digital Audio Processor - Manual (Page 16)

12
D*AP LM 4
Web GUI – SYSTEM – Setup
Setup – Allows the editing of program labels for the 2 stereo input sources along with the sync source
selection. Displayed to the right is the PRESETS window which is common to many of the set up screens.
Presets allow for up to 20 different parameter settings that can recalled when desired.
Program Labels each of the individual programs has a name that will be used as a
reference for the display of parameters and its setup.
D*AP Synchronization Source with this pull down you may select between the available sync
sources :
Internal 48kHz, External AES, Input AES 1/2, External WCL,
Interface (if an option board is installed),
Black Burst / TriLevel).
Web GUI – SYSTEM – The Preset concept in detail
The example above shows the preset concept of the LM 4. It is the central theme of the device.
For all relevant setting of the device one set of ON AIR parameters and 20 sets of PRESETS are available If
you want to load parameters from a preset or save parameters from the ON AIR area
to a preset, you must first select a preset number at the bottom of the ON AIR page.
You must press
to open the pull down list to select the desired preset.
Pressing will execute it. When you press , you will be asked in a pop up :
to overwrite the selected preset and to give it a (new) name.
acts as a clip board for the parameters of individual presets,
while will allow you to store / recall the set of 20 presets to / from the PC file system.
Important note! The presets of the LM 4 are persistent by nature. You are working directly on the preset
memory, i.e. you must not worry about storing such presets. The LM 4 does it for you.