Junger Audio D*AP LM2 / D*AP LM4 - Digital Audio Processor - Manual (Page 35)

31
D*AP LM 4
Mode
[OFF, Always ON, AUTO]
sets the voice over operating mode
Signal Path [Pre Leveler, Post Leveler]
the position in the signal path regarding the leveler processing block.
You will also see it in the AUDIO PROCESSOR > Overview sketch,
highlighted in green and surrounded by a solid line that surrounds the
Voice Over processing block in use.
Attenuation (dB) [-30 … 0dB]
the attenuation of the program signal in case of active voice over
Timing
Fade In Time (ms) [10 … 1000]
Hold Time (s) [0.0 … 10.0]
Fade Out Time (s) [0.0 … 10.0]
Voice Over Source
Source Format [Stereo, Mono LL, Mono RR, Mono L+R]
the voice feed of the Voice Over circuit is a two channel signal. You
may select here, from which input channel the voice feed will be
taken.
LL for example means the voice signal is taken from the first input
channel and it will be mixed into both program channels. Mono L+R
means that a mono signal is built from a stereo input signal and is
mixed to both (stereo) program channels.
Source Gain (dB) [-20 … 20]
sets the gain for the voice signal prior to mixing.
Threshold (dBFS) [-60 … -40]
the threshold for the voice signal in AUTO mode.