Junger Audio D*AP LM2 / D*AP LM4 - Digital Audio Processor - Manual (Page 47)

43
D*AP LM 4
3.
Decide what shall happen we will do this gain change by loading respective presets for the
input section of the audio processor for program 1.
Therefore we must set up two presets for the input section of
program 1 : Preset 1 = "plus 1dB", Preset 2 = "minus 1dB"
4. Assign Trigger to events because we are about to load presets we must set up
preset events for the audio processor :
"EVENTS > Preset Events > Audio Processor".
On this pane we select the trigger "Input Gain +1dB"
and "Input Gain -1dB" respectively and we give these two events the
names "Prog1 Gain up" and "Prog1 Gain down":.
Finally we must assign it the two pre defined presets from the audio
processor input section – that's it :
This is just an example to underline the power of the event management system of the LM 4.
Junger Audio provides you with the tools to support your creativity to deal with events of your interest.