Proceed CVP2 - Manual (Page 31)

31
Specifications
■
Pass-through gain : +0.0 dB, - 0.2 dB
■
Pass-through frequency response : +0.25 dB, - 3.0 dB to 70 MHz
■
Pass-through differential gain : less than 0.2%
■
Pass-through differential phase : less than 0.2 °
■
Decode/encode path gain :
±0.2 dB
■
Decode/encode path frequency response :
Composite & S-video inputs +0.2dB, -1.0 dB to 5.0 MHz
Component inputs +0.2dB, -0.5 dB to 5.0 MHz
■
Decode/encode path differential gain :
To Composite output less than 2%
■
Decode/encode path differential phase :
To Composite output less than 1
°
■
Decoder composite input filter : 4 line adaptive comb filter
■
Composite & S-video inputs : NTSC or PAL, autodetecting
■
SD Component YP
b
P
r
inputs for decoding : SMPTE standard levels
Y channel -300 mV sync, +700 mV peak
P
b
/P
r
channels
±350 mV
Field rate 50 or 60 Hz interlaced, autodetecting
■
SD Component RG
s
B inputs for decoding :
G channel -300 mV sync, +700 mV peak
B/R channels +700 mV peak with or without sync
Field rate 50 or 60 Hz interlaced, autodetecting
■
Maximum input signal offset, all inputs :
±2VDC
■
Input impedance, all inputs : 75
Ω
■
SD encoded YP
b
P
r
output levels : SMPTE levels
■
SD encoded R
s
G
s
B
s
output levels :
w/60 Hz input -286 mV sync all channels, +714 mV peak
offset +337 mV
w/50 Hz input -300 mV sync all channels, +700 mV peak
offset +352 mV
■
Output impedance : 75
Ω
■
Crosstalk : better than -55 dB @ 10 MHz
better than -45 dB @ 35 MHz
■
RS-232 “to controller” port :
Baud rate 38.4 kbaud
Data bits 8
Parity None
Stop Bits 1
Data format AVP2 ASCII commands only
(see AVP2 documentation)
Pinout Tx=pin 3
Rx=pin 2
Ground=pin 5
(continued next page)