Proceed PCD - Manual (Page 20)

20
Programming
In “Basic operation,” you learned how to play tracks as ordered on the
CD. In this section, you’ll learn how to:
■ Enter and play a program of up to twenty tracks or indexes, in
any order;
■ Play a program;
■ Replay a selection;
■ Skip to another selection in a program;
■ Find a particular passage in the program;
■ Suspend play using the “pause” function;
■ Repeat an entire program;
■ Stop play; and
■ Erase the memory.
Rather than playing an entire CD, you may choose to play only
certain selections. To do this, you'll need to create a “program” and
store it in the PCD 3/PDT 3's memory. The memory will accept up to
twenty entries.
Entering a program is possible only before play begins.
To enter a program:
1. Load a CD into the drawer, and wait for the Display to show the
total number of tracks and their total playing time. (See “Basic
operation.")
2. Select the first track or index in your program using the next, prev,
next index, and prev index, or the numbered buttons on the
Remote Control. (See “Basic operation.") The LED above the
progm button will flash while you're making your selection.
3. Enter your selection into memory by pressing progm. The LED
above the progm button will light and the Display will show "P."
Note: You must press progm within five seconds after making a
selection, or the selection won’t be entered into the memory.
4. Select and enter the rest of the program (up to twenty selections)
by repeating steps 2 and 3, making sure to press progm after each
selection.
5. To begin playing the program, press play. The LED above the
progm button will light and the "P" will disappear from the Display.
To return to the beginning of a selection while it is playing, press play.
Play will be suspended briefly, then that selection will replay followed
by the rest of the selections in the program.
Entering a program
Replaying a selection
in the program