Tempest Thunder - Manual (Page 13)

Thunder Enclosure User Manual page 13
Mounting the Yoke and Hanger Kits
1. Remove the two ¼-20 screws, nuts and washers from the enclosure base. Do not discard.
2. Remove the two 5/16-18 nuts and washers from the yoke or hanger kit. Do not discard.
3. Insert the two studs in the yoke or hanger kit in the two larger holes in the enclosure
base.
4. Secure in place with the nuts and washers from steps 1 and 2
Mounting the AAdynTech Punch Plus Luminaire
1. Remove the Yoke and yoke hubs from the luminaire.
2. Remove the two 10-32 x 1” flathead screws from the front/top of the luminaire
3. Attach the fixture mounting bracket supplied with the Thunder 6670 enclosure, using the
two screws removed in step 2
4. Back off the two brass thumbscrew nuts in the enclosure base so that they are
approximately ¼” [6mm] from the base.
5. Lift the luminaire into position over the thumbscrew nuts and slide backwards about ½”
[12mm] so that the back of the luminaire engages with the rear luminaire mount.
Fixture Bracket
Mounting Screws removed
from Luminaire
NOTE:
For standing use, remove the
locking knobs and bolts from
both sides, swing the outer
yoke down and replace the
locking bolts and knobs.