wePresent WiPG-2000 - Manual (Page 5)

5
Safety
1. Compliance IC
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-003 and RSS-210.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the AWIND Wireless Device is below the Industry
Canada (IC) radio frequency exposure limits. The AWIND Wireless Device should be
used in such a manner such that the potential for human contact during normal
operation is minimized.
WiPG-1500 IC No.: 11600A-WIPG1500S
Antenna Information and Compliance:
This radio transmitter (IC:11600A-WIPG1500S, or WiPG-1500 if Category II)
has been approved by Industry Canada to operate with the antenna types listed
below with the maximum permissible gain and required antenna impedance for
each antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for
use with this device.
Antenna Part Number:AN2400-5791RS, Antenna Type (Dipole), Gain 2.55dBi,
Impedance 50 ohms[Main]
Antenna Part Number:AN2400-5791RS, Antenna Type (Dipole), Gain 2.55dBi,
Impedance 50 ohms[Aux]
Caution: Exposure to Radio Frequency Radiation
To comply with RSS 102 RF exposure compliance requirements, a separation
distance of at least 20 cm must be maintained between the antenna of this device
and all persons.