Argox PT-60 - Manual (Page 20)

User’s Manual 15
2.4.2 Charging the Battery Pack with Cradle
Figure 2-10 Charging with Cradle
a) Leaving the battery pack inside the Mobile computer
1. Connect the power adaptor to a power source
2. Plug in the connector of the power adapter to the Cradle
3. Insert the Mobile computer into the Cradle
Note: When charging the battery pack, the Power LED on the Mobile computer turns
Red. After the battery pack is fully charged, the Mobile Computer Power LED
turns green.
b) Placing the spare battery pack into the Cradle’s spare battery charging slot
1. Connect the power adapter to a power source
2. Plug in the connector of the power adapter with Cradle
3. Insert the battery pack into the Cradle’s spare battery slot
Note: When charging the battery pack in the Cradle’s spare battery slot, the Cradle
charging LED is Red. After the battery pack is fully charged, the LED turns green.
Caution: Ambient Temperature Ranges for the Battery Pack

Temperature ranges for battery pack use in the terminal, charging,
and storage is specified below. Temperatures outside these ranges
create the danger of deterioration of battery pack performance and
shortening of its service life, as well as fluid leakage and heat
generation.
Operating Temperature: -20 to 50
Charging Temperature 0 to 40
Storage Temperature: -20 to 60

If the battery pack charge indicator does not light during charging,
remove the battery pack and then re-attach it. If this does not solve
the problem, it means that the battery pack is defective and needs to
be replaced.

Use only the specified battery pack.

Battery packs naturally discharge even when they are not loaded in
the terminal. Use a battery pack as soon as possible after charging it.

For best charging results, keep the cradle, terminal and battery pack
contacts clean by periodically wiping them off with a cotton swab or
dry cloth.