Avalon Firestyles 864 See-Thru GS2 Installation - Manual (Page 19)

Installation
(for qualified installers only)
19
© Travis Industries 4141208 100-01404
Gas Line Location
NOTE FOR RIGID PIPE: When using rigid pipe, you may wish to disconnect the shutoff valve from the fireplace
and route the pipe through the fireplace wall. First, disconnect the gas line from the shutoff valve (see step 1
below). Then remove the shutoff valve from the cover plate (4 screws outside fireplace). The pipe may be routed
through the cover plate and the shutoff valve and gas line may be re-attached inside the fireplace.
Converting Gas Line to the Left Side
1. Disconnect the gas line from the shutoff valve (3/4” wrench). Gas line is located inside the fireplace on the
right side.
2. Remove the screw that holds the shutoff valve plate in place (1/4” nutdriver). Remove the shutoff valve plate.
3. Remove the cover plate from the left side of the fireplace (it is held in place in the same fashion as the shutoff
valve plate). Attach it to the right side of the fireplace.
4. Attach the shutoff valve plate to the left side of the fireplace. Route the gas line to the left side and re-attach
the gas line to the shutoff valve. Make sure to leak test the entire gas line.
The gas inlet is located 3.375" (86mm)
above the base of the fireplace.
7"
178mm
9"
229mm
Right Side Gas Inlet (Stock)
Left Side Gas Inlet (requires addtional flex connector)
6.625"
169mm
The gas inlet is located 3.375" (86mm)
above the base of the fireplace.