Finalizing the installation, Installation – Avalon Firestyles Salish-1999 to 2000 User Manual
Page 14
14
Installation
(for qualified installers only)
Travis Industries
9 3 5 0 8 1 0 7
1 0 0 2 0 1
Finalizing the Installation
!
Turn the gas control valve to ÒOFFÓ prior to conducting any service.
1
Open the door (see page 16).
2
Install the log set and coals (see page 17).
!
We recommend you purge the gas line at this time (with the door open). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3
Close and secure the door (see page 16).
4
Turn on gas to the heater. Leak test all gas joints prior to starting the appliance. Start the pilot. Start
the main burner. Leak test all gas joints again.
5
Check the pilot flame to make sure it looks like the illustration below. Adjust the pilot flame if
necessary.
PILOT ADJ
T
O
L
PI
ON
OFF
Standard
Screwdriver
Micro (1/16Ó)
Standard
Screwdriver
Cover Screw
Cover Screw Gasket
Needle Valve
Thermopile
Pilot Hood
3/8Ó
Thermocouple
The pilot flame should touch
only the top 3/8Ó of the
thermopile. Adjust the pilot up
or down as necessary.
To adjust the pilot flame, remove the cover screw and gasket and turn the needle
valve (NOTE: if the needle valve is totally unscrewed, gas will come out of this port).
Clockwise lowers the flame while counter-clockwise raises it. Replace the cover
screw and gasket