Avalon Firestyles Salish-1999 to 2000 - Manual (Page 30)

30
Optional Equipment
Travis Industries 9 3 5 0 8 1 0 7 1 0 0 2 0 1
5 Install the logs and embers.
6 Shut the door.
7 Remove the regulator from the front of the gas control valve. Replace with the propane regulator,
using the new gasket and screws included with the regulator. NOTE: Leak test this area after
the heater is installed, gas is connected, and the main burner is lit.
These screws hold the
regulator in place.
NOTE: use the new
screws included with
the regulator.
Phillips
Screwdriver
PILOT ADJ
T O L PI
ON
OFF
VENT
HI
LO
VENT
HI
LO
Align the regulator
gasket so it is flat
and the two tabs fit
through the two
holes on the
gasket.
Regulator Gasket
NOTE: use the new gasket
included with the regulator.
LP (propane) regulators have a
11.0 2.7 stamped here.
NOTE: These holes strip
easily. Use a hand
screwdriver and tighten
each screw evenly.
8 Place the included propane label over the natural gas
label on top of the gas control valve.
THIS CONTROL
HAS BEEN
CONVERTED TO
LP
9 Make the gas line connection, start the heater and thoroughly leak-test all gas connections and the
regulator. Check the pilot. Adjust if necessary.
PILOT ADJ
T
O L PI
ON
OFF
Standard
Screwdriver
Micro (1/16Ó)
Standard
Screwdriver
Cover Screw
Cover Screw Gasket
Needle Valve
Thermopile
Pilot Hood
3/8Ó
Thermocouple
The pilot flame should touch
only the top 3/8Ó of the
thermopile. Adjust the pilot up
or down as necessary. To adjust the pilot flame, remove the cover screw and gasket and turn the needle
valve (NOTE: if the needle valve is totally unscrewed, gas will come out of this port).
Clockwise lowers the flame while counter-clockwise raises it. Replace the cover
screw and gasket