Paxar Monarch 9855 RFID Printer - Manual (Page 15)

C o n n e c t i n g t h e C o m m u n i c a t i o n C a b l e
Connect the communication cable into the appropriate port.
Secure the cable with the connecting screws (serial) or spring
clips (parallel).
If you are communicating with the host through the serial port,
make sure the printer’s communication values match those at the
host. The factory default values are 9600 Baud, 8 bit data frame,
1 stop bit, no parity, and DTR flow control. The printer also has a
USB (Universal Serial Bus) Version 1.1 communication
port. Drivers are available on our Web site for a variety of
operating systems.
The printer supports a baud rate up to
115200. Make sure your host is capable of
communicating at the speed you
select for the printer.
U s i n g t h e C o n t r o l P a n e l
The control panel has a two-line LCD display, 2 status lights, and
five buttons. The control panel displays error codes/messages,
and allows you to setup/configure the printer.
P r i n t e r S t a t u s L i g h t s
Power:
The printer shows a steady green light
when it is on.
Fault:
The printer shows a blinking amber
light when there is a printer error.
Getting Started 1-5