Baby Lock BL9 (BL9) Instruction and Reference Guide - Manual (Page 20)

16
x
c
v
n
m
(A)
(B)
Winding the Bobbin
z Pull the handwheel out.
x Draw the thread from spool.
Guide the thread around the bobbin winder thread guide.
c Insert the thread through the hole in the bobbin from
the inside to the outside.
Align the notch (A) of bobbin to the bobbin winder
spindle rib (B).
Put the bobbin on the bobbin winder spindle.
v Push the bobbin to the right.
b With the free end of the thread held in your hand,
depress the foot control.
Stop the machine when it has made a few turns, and
cut the thread close to the hole in the bobbin.
n Depress the foot control again.
When the bobbin is fully wound, stop the machine.
Return the bobbin winder spindle to its original position
by moving the spindle to the left, and cut the thread.
m Push the handwheel to the left. (original position).
Threading Bobbin Case
z Place the bobbin into the bobbin case.
Make sure the thread unwinds in the direction of
arrow.
x Pull the thread into the bobbin case slot.
c Draw the thread under the tension spring and into
the delivery eye.
* Leave about 10 cm (4˝) of free thread.
z
b
z
x
c