Baby Lock BL9 (BL9) Instruction and Reference Guide - Manual (Page 36)

32
w e
r t
q
q Pattern selector:
w Presser foot:
Zigzag foot
e Thread tension: 1–3
r Stitch length: Any
t Darning plate
Use the darning plate for button sewing. (see page 24.)
Sewing Buttons
Adjust the stitch width with the pattern selector dial,
and turn the handwheel to check if the needle enters
into each hole in the button.
Lower the foot to hold the button in place.
The holes in the button should align with the slot of
the foot.
A pin can be placed on the foot to form a shank.
Make sure to check if the needle enters into both holes
on the button.
Sew about 10 stitches and cut the needle and bobbin
threads, leaving 20cm (8") tail.
Bring the needle threads between the button and fabric
through the holes on the button.
Pull the needle threads to pick bobbin threads up to
the right side of the fabric.
Wind the threads to form a shank and tie them together.