Becker mamba.4 LMU plus - Manual (Page 28)

28
>>> GENERAL OPERATION
> Press the button for the required
language.
> The selection is confirmed by pressing
OK .
> Then select the desired voice.
A short example announcement is given.
> Confirm your selection by pressing the
OK button.
The following prompt appears shortly af-
terwards:
If you agree to the request contained in
this prompt, press the
OK button.
Switching off (depending on model)
You can switch off the device at any time.
> Press the button on the right-hand
side of the device.
The Navigation device switches to sleep
mode.
> Press the switch on the right-hand
side of the device for longer than 3
seconds to finally switch it off.
Note: for models with TTS
Voices with a (TTS) tag support the text-
to-speech function (e.g. announcing
roads and reading out text messages).
Note:
Use of the Navigation device is only
permitted in accordance with the
national road traffic regulations
applicable at the time.
Note:
We recommend that you place the
Navigation device in sleep mode in the
event of short interruptions to operation
(of up to a week).
This significantly reduces the switch-on
time and the Navigation device finds the
satellites required for navigation much
faster.
If route guidance was active when sleep
mode is activated, it is automatically
resumed if the Navigation device is
switched back on again within approx. 4
hours.
If the device cannot be switched off
anymore or no longer works reliably, it
is possible to switch off devices without
I/O switches completely by pressing the
button on the top for longer than 7
seconds.