Becker TRAFFIC ASSIST 7914 - Manual (Page 22)

22
*HQHUDO RSHUDWLRQV
$GMXVWLQJ WKH XQLW EUDFNHW
The support plate (7) can be swung
in two directions (horizontally and verti-
cally). It can thereby be set at virtually
every angle of vision to the driver.
9HUWLFDO PRYHPHQWV
X Loosen the locking screw (2) until the
support plate (7) can be swung from
top to bottom without too much effort.
X Use one hand to hold the foot (5) and
swing the support plate (7) up to the
centre or down into the position you
want.
X Retighten the locking screw (2) again
so that the Traffic Assist is secure for
travel.
+RUL]RQWDO PRYHPHQWV
X Loosen the locking screw (1) until the
support plate (7) can be swung from
left to right without too much effort.
X Use one hand to hold the foot (5)
and swing the support plate (7) to the
left, to the centre or to the right into the
position you want.
X Retighten the locking screw (1) again
so that the Traffic Assist is secure for
travel.
$GGLQJ WKH 7UDIILF $VVLVW
The unit bracket on the carrier plate (7)
features a guide for holding the Traffic
Assist (6). This in turn features a suitable
recess.
X Place the Traffic Assist on the
guide on the unit bracket with the
unit’s recess at the top.
X Slide the Traffic Assist carefully into
the guide from above until the stop is
reached.
1RWH
Do not swing the support plate in both
directions at the same time! Before
moving, always take the Traffic Assist
off the unit bracket.
5015