Becker TRAFFIC ASSIST 7914 - Manual (Page 27)

27
*HQHUDO RSHUDWLRQV
7UDQVIHUULQJ XVLQJ WKH 86%
SRUW
The USB port is used to link the Traffic
Assist directly to a personal computer.
For transfers, the Microsoft
®
Active Sync program must be installed
on the computer. This is available free-
of-charge from the manufacturer.
The link then involves several steps:
X switch off Traffic Assist.
X link the Traffic Assist and computer
using the USB cable.
X switch the Traffic Assist back on.
ActiveSync automatically sets up a link
to the Traffic Assist.
7UDQVIHUULQJ PDSV
The installation software from the DVD
should be used for the transfer. This in-
volves the following stages:
X switch off Traffic Assist.
X remove memory card and plug into an
SD card reading device or the use the
USB cable to connect the Traffic As-
sist to the computer.
X boot up the computer and insert the
DVD.
X use the installation program to transfer
the map required.
X slide the memory card back into the
Traffic Assist or correctly remove the
USB cable.
X switch the Traffic Assist back on. The
new map is available right away
7UDQVIHUULQJ SLHFHV RI PXVLF
DQG SLFWXUHV
Since the map data takes up virtually all
the 1GB memory capacity of the memo-
ry card supplied, pictures and music
should be saved on to another SD card.
The files can be transferred via a card
reader or the USB connection.
5017
1RWH
Use obvious folder names because
these will help you later when you are
trying to find the file you want in the
Traffic Assist.