BUG-O Systems SE-4PTD User Manual
Page 12
12
Data Entry
When entering data on the keypad, multiply inches, degrees, or seconds by 100 and enter the
number without a decimal point. For metric dimensions, multiply mm x10 or cm x100.
For Example:
350 for 3.5 inches,
800 for 80mm on metric machines
1500 for 15°
Press the return button after the number is entered.
Data Required:
TYPE 1: Requires 1. Small diameter (pipe being cut)
2. Large diameter (pipe it fits on)
TYPE 2: Requires: 1. Small diameter
2. Large diameter
3. Offset distance between centerlines
TYPE 3: Requires: 1. Small diameter
2. Large diameter
3. Offset
4. Angle between pipes
TYPE 4: Requires: 1. Small diameter
2. Cutback distance
3. Angle of mitre cut
For plasma cutting, a value for the time delay is also required to allow for the delay in striking the arc.
A commonly used delay is 3 seconds (enter 300 on the terminal keypad).