BUG-O Systems SE-4PTD - Manual (Page 7)

7
PANEL CONTROLS
The function of various buttons and knobs on the control panel are described below:
START (Black push-button):
Computer control is interrupted when pushed until the start button or Reset button is pushed. If
pushed while running, the torch is shut of and the SE-4PTD stops. Pushing the start button again
will resume the cut. When Stop is pushed, the machine can be manually positioned by the joystick
switch; this does not change the home reference position unless the Rest button is again pushed.
RESET (Small push-button):
Reset the computer when pushed and makes whatever position the machine is in the home refer-
ence position. If the torch or pipe is moved by the joystick, upon releasing it, the SE-4PTD will
return to the home position.
SPEED knob:
Controls the tangential speed of the torch along the cut, from zero to maximum. The speed will
depend on the diameter of the pipe. When the torch arm is moving in or out, the rotational speed
will slow down to keep the resultant speed constant.
SE-4PTD PANEL CONTROLS
WELD
CONTACT RESTART START STOP MANUAL JOG
TO PENDANT
CONTROL
SPEED
CONTROL
POWER
CORD
POWER INDICATOR POWER ON/OFF CIRCUIT BREAKER
LIGHT