BUG-O Systems SE-4PTD - Manual (Page 16)

16
For Example, a 2 inch diameter circle could be four segments:
1. 2, 1, 100 Counterclockwise arc, quadrant 1, 1.00 inch radius
2. 2, 2, 100 Counterclockwise arc, quadrant 2, 1.00 inch radius
3. 2, 3, 100 Counterclockwise arc, quadrant 3, 1.00 inch radius
4. 2, 4, 100 Counterclockwise arc, quadrant 4, 1.00 inch radius
The data should be tabulated on paper from a diagram before entering.
B. Program Segment
Press B on terminal to re-program a single segment. This is useful if there is an error in data for
just one segment, so the whole shape does not have to be re-entered.
C. CHANGE shape number
Press C on terminal to change the current shape number, and enter the desired number at the
prompt. The program switched to the new number in memory, and to whatever shape is
stored there.
D. DISPLAY Shape Data
Press D to display the data for the current shape. The terminal display shows total No. of seg-
ments, and data for each segment one by one each time you press enter.
E. END of segment Slowdown
Press E to set deceleration value for the shape, when the machine approaches the end of each
segment. This is useful when the shape has sharp corners, to prevent overshoot. 99 is maxi-
mum slowdown, 0 is no slowdown.
IMPORTANT
1. Once the Hold button is pressed, computer control is halted until the RUN or the resent button is
pressed. Therefore the programming cannot be done with the hand held terminal in this state; the
Reset button should be pressed first.
2. After pushing A and programming a new shape, End of Segment Slowdown will still have the old
value unless reprogrammed. To Set a new value, push E.