ConnectGear WA660N - Manual (Page 35)

28
Here are descriptions of every setup item:
Band
Please select the wireless band you wish to use. By
selecting different band setting, you’ll be able to
allow or deny the wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz
(G), only wireless clients using the wireless band
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless
clients using 802.11b and 802.11g band will be
able to connect to this access point.
If you want to allow 802.11b, 802.11g, and 802.11
Draft-N clients to connect to this access point,
select 2.4GHz (B+G+N).
Main ESSID Please input the ESSID (the name used to identify
this wireless access point) here. You can input up
to 32 alphanumerical characters. PLEASE NOTE
THAT ESSID IS CASE SENSITIVE.
Site Survey When you use this access point as a wireless
station for Ethernet network device to have
wireless capability, you have to associate it with a
working access point. Click ‘Select Site Survey’
button, then a “Wireless Site Survey Table” will
pop up. It will list all available access points near
by. You can select one access point in the table and
it will join wireless LAN through this access point.
Please go to Section 2-4-2-1 for more information
about the ‘Wireless Site Survey Table’.
After you finish with setting, please click ‘Apply’, and the following
message will be displayed: