ConnectGear WA660N - Manual (Page 40)

33
2-4-4 AP Bridge-Point to Multi-Point Mode
In this mode, this wireless access point will connect to up to four wireless
access points which uses the same mode, and all wired Ethernet clients of
every wireless access points will be connected together. You can use this
mode to connect a network to other networks which is physically isolated.
Please note that when you set your access point to this mode, it will not
accept regular wireless clients anymore.
When you select ‘AP Bridge-Point to Multi-Point’, the following options
will be displayed:
Here are descriptions of every setup item:
Band
Please select the wireless band you wish to use. By
selecting different band setting, you’ll be able to
allow or deny the wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz
(G), only wireless clients using the wireless band
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless
clients using 802.11b and 802.11g band will be